Training — 3d printer calibration
Posted by 3D Printing SA Admin on
What is the correct way to do 3D Printer calibrations? One of the most time consuming and controversial thing on a 3D printer is calibration. Once you have build your printer then it needs to be calibrated and tested. Below is a typical square calibration cube used. Image from 3DHubs and user Christiaan What most of us, including myself did was to print it measure it and then adjust the steps in Marlin firmware then load it and print it again and again until we are satisfied. Most 3d Printer has a printing area of at least 200mm and these...
- 0 comment
- Tags: 3d printer calibration, Calibrating your 3D Printer, calibration sticks, Prusa I3 calibration